The safety operating procedures and key points for installing a mobile loading ramp are crucial during the installation process. This article will first introduce the safety operating procedures for the mobile loading ramp and then provide detailed explanations and instructions for important aspects during the installation process.
Safety Operating Procedures:
1. Adjust Height:
Use the hydraulic lever to adjust the mobile loading ramp to the desired height, typically higher than the truck’s cargo bed.
2. Vehicle Positioning:
Reverse the truck to the tongue plate area of the loading ramp, ensuring the tongue plate makes smooth contact with the bottom of the truck’s cargo box.
3. Lower and Secure Tongue Plate:
Open the manual pump valve, allowing the tongue plate of the loading ramp to slowly descend, pressing it onto the bottom of the truck’s cargo box, then lock the manual pump valve.
4. Stabilize Support:
Lower the support frame of the mobile loading ramp, ensuring the loading ramp is stably supported on the ground.
5. Secure and Connect:
Use the hooks on both sides of the loading ramp lip to secure the mobile loading ramp to both sides of the truck to prevent separation.
6. Brake Block Placement:
Place brake blocks on both sides of the mobile loading ramp behind the tires to prevent wheel slippage.
7. Ground and Truck Connection:
Lower the tailboards on both sides of the mobile loading ramp to create a sloping ramp and connect the ground to the truck.
8. Confirm Safety and Stability:
Confirm that the equipment is securely fixed, the support frame is stable, and the brake blocks are effectively placed before using the mobile loading ramp.
Key Points for Installation：
1. Electrical Aspects:
Ground Resistance Measurement:
Measure ground resistance to ensure compliance with specified requirements.
Control Switch Inspection:
Inspect the normal operation and protective functions of the control switch.
Ensure correct motor installation and alignment with the marked direction.
2. Guide Rail Installation:
Lubricate the guide rails before installation to ensure proper lubrication.
Check the verticality of the guide rails to ensure they fall within allowable deviation.
3. Frame Installation:
Installation Distance and Angle:
During initial installation, maintain a distance of 4.5-6 meters from the base, adjusting to 9 meters afterward. The horizontal tilt angle should be kept within 10 degrees.
These key points and safety operating procedures are vital for the safe installation and use of the mobile loading ramp. It is essential to adhere to and remember these steps to ensure safe, efficient, and smooth operations.